Saturday 8th August - I finally drive the Lotus!

 Todays main task was to finally drive the Lotus Cortina out of the garage and hopefully round the block a few times. I still had a few things to do on the Green Cortina first though and being my only show car at the moment, this has to take priority.  I had carried out a compression test on the car just to see if I had a head gasket problem. The engine had been rebuilt a couple of years ago and to be honest I can't remember re-torquing the cylinder head. 
So I had carried out a compression test and re-torqued the head during the week, so this morning I just had re-fit the rocker cover and air filter and then carry out another compression test. The results of the two tests can be seen below. There's not a great deal of difference, but they are at least within 10% of each other now. Plus it rules out any head gasket issues. 

My next job was to re-fit the rear bumper again. I wasn't completely happy with the finish when it was hydrochromed, so the guy who did it offered to do it again free of charge. It looked much better this time as you can see.

Next on the list was to make a thicker throttle bracket for the Lotus Cortina as the previous one I'd made was a little bit slack. I used thicker metal this time and although it still flexes a bit, it's better than it was. After prepping the car I was ready to start it and it fired up no problem. I spotted an initial water leak, but this was only a loose jubilee clip. With this tightened the dripping stopped. 
I then drove it round the crescent a couple of times. It drove great and sounds great too. However, lifting the bonnet revealed that the repairs my mate Gavin had done to the pin holed radiator hadn't taken and it was spraying out water and it was also  leaking engine oil from somewhere. How disappointing. 😔

I quickly got the picture I had been waiting to get ever since I bought the car, (see below) and then put the car back in the garage. 

Further investigation revealed that the oil leak could be a crankshaft seal, and after speaking to my engine my engine builder, we've decided to sort the rad out first, then the car will be going to his workshop for investigation and repair. 

I was very disappointed, but the at least the test drive revealed that the brakes, clutch etc are all fine and it's only these bits that need doing. (it will need a rolling road session though to set the twin 40's up properly. 
The main thing is though, I have now driven my dream car, the Mk1 Lotus Cortina. And I loved it! I will persevere and I will make this car this great again. Watch this space! 😊