Since owning the Green Cortina I've always felt that the steering had a lot of play in it. I'd always put it down to the fact that it was due to it having a steering box, rather than rack and pinion steering which is far more accurate.
However when you compare it to driving the Zetec Cortina the two cars are worlds apart. The Zetec steering feels nice and tight while the Green car resembles sailing a boat in force nine gales.
While the engine is out of the Green car I felt that now would be the best time to remove the steering box and get it refurbished. Having no engine in the car gives you a lot more room to work. So after speaking to a few Cortina friends for advice and reading the workshop several times, I decided to bite the bullet and get stuck in. In situations like this, I always think back to what one of my ex-girlfriends, Amanda, said to me, which was: 'Sometimes, the THOUGHT of doing something is worse than the actual doing it'.
So with this ringing in my ears I made a start. I'd had to work as well today, but started very early so that I could have a good few hours in the afternoon to get the job done. (I had to deliver one car to Margate in Kent, then come back and deliver another car to Maldon in Essex. I started at 5am and was finished by 12pm.
Anyway, I digress, so I drank my cup of coffee while staring into my empty engine bay while trying to figure out how the hell the steering box (and column-they cant be disconnected whilst in the car) would be able to exit the car from underneath. (That's what the workshop manual had said!)
The first job was to remove the steering wheel, then the indicator and headlight arm and then the column shroud. I then found two crosshead screws that had to be removed to relieve grip on the column. Next was to remove the parcel shelf so that I could remove another bolt that holds the column to the pedal box. The last to do inside the car was undo the metal plate that the column goes through via the firewall. This also has a foam gasket which I knew was completely knackered, but luckily my friend Keith has one for sale and will be bringing it to the Battlesbridge autojumble for me to collect.
Work then moved to inside the engine bay where I had to disconnect the pitman arm on the steering box from the steering link. This caused no problems and I was now at the stage where the car had to be jacked up and placed on axle stands to provide enough room to manoeuvre the steering box out from underneath.
I also found out at this point that it's easier to remove the offside front wheel to gain access to the three bolts that secure the steering box to the chassis rail. (The workshop manual didn't mention that!) Once I'd removed the three bolts the steering box was free, but I still couldn't find enough room from underneath to remove it. I then decided to disconnect the track rod from the drop arm and this then gave me enough room to 'manoeuvre' the steering box out of the car. (The workshop manual never mentioned that either!)
So the job that I had been dreading for months and months was now complete. It took just under two hours. It will now be taken to a steering box specialist in West Thurrock in Essex when time permits. I'm not sure I would have fancied doing it with the engine in place though, so I definitely wont be refitting the engine until the steering box is refurbished and back in the car! 😊
No comments:
Post a Comment